SSP-G Gear Set 16*42 (Honda Dio)
Description: SSP-G gear Set 16*42 for Honda Dio\Elite. The final drive ratio is the last bit of gearing between your transmission and the driven wheels. In general, a lower final drive ratio will lead to less torque at the wheels but higher top speed. Meanwhile, a higher ratio will result in the opposite, i.e. more torque at the wheels but lower top speed. Get the most out of your big bore kit, with increased top speed and a more usable rev range performance.
Since the Honda Dio\Elite transmission stock gear teeth are 13*49 which = gear ratio 3.769:1 this means the stock gear 13-teeth counter shaft has to turn 3.769 full-turns to drive 1 full-turn of its 49-teeth final drive gear thus turns its final drive axle which the rear wheel spin freely on.
Gear Set 16*42 = ratio 2.625:1 is best for stock/mild 70-90cc builds. We suggest going to this 16*42 taller gear set if you planning on plain road top-speed riding.
Here's how to calculate the gear ratio for Gear Set 16*42 Just divide the number of final drive gear teeth 42 by the number of the counter shaft teeth 16. It's 42 / 16 = 2.625:1 gear ratio. This means the 16-teeth counter shaft gear takes 2.625 full-turns to drive 1 full-turn the larger 42-teeth drive gear. Overall it will take less counter shaft gear turn for the rear wheel to spin compared to the stock gear ratio.
Now you know. Get the most out of your big bore kit, with increased top speed and a more usable rev range performance with the right transmission gear set changed.
NOTE: Not included, must reuse stock 54-teeth counter shaft gear, easily slide on. However, a 12-ton hydraulic compressor is required for removing the stock 49-teeth rear final drive gear off its final drive shaft and then re-pressing the final drive shaft onto this new 42-teeth rear final drive gear. Please compare OE dimension before ordering to assure correct fitment.
Include the following Transmission gear set.
• 1x Front Counter Shaft Teeth: 16 / Spline L: mm / OD: 30mm / Overall L: 58.44mm
• Short Spline Area L: mm x OD: 16mm / Ends L: mm x OD: 14mm
• 1x Rear Final Drive Gear Teeth: 42
• OD: 65.4mm / ID: 17mm / W: 18mm
• Fit Variator Boss 20mm
• Fit Roller Weights: 16x13mm
• Fit Plastic Slides
• Fit Belt Size: 654x18x30mm
• Fit Belt Size: 669x18x30mm
• Fit Compression Spring: 1k, 1.5k, 2k rpm
• Fit Dowel Pin Set (8x14mm)
• Fit DIO 50/90cc+
Supported Models: TFC CVT KIT (Part# 179-2); Honda Dio AF16 AF18E 50; Elite S/SE/SR 1994-2001, Daelim Cordi 50, Kymco Fever/ZX50, SYM DD50, and virtually any scooter engine with these measurements.-----
Item Weight & Package Dimensions:
• 1 pound | 6.85" (L) x 4" (W) x 1.43" (H
Sorry, this video is NOT dubbed in English. Punjabi speaking only.
People Also Bought
From Same Category
- Stock: 38
- Reward Points: 2
- Part #: 169-552-16F/42R