NCY Throttle Grip 7/8in CVK Cable Set (GY6, Ruckus, Universal)
Description: NCY Throttle Grip 7/8 in CVK Cable Set for Honda Ruckus Boost your throttle response on your scooter with this quick draw throttle from NCY. Will work with any 7/8 (22mm) handlebars. It comes with a matching left grip and 75" throttle cable. This throttle tube assembly works on any scooter with 7/8" diameter bars. Not for dual throttle cable setup.
If you need a longer CVK throttle cable due to that Honda stretch this is it can be used on Honda ruckus with a CVK carburetor. We recommend that you measure the original cable and check the detailed photos for accuracy.
NOTE: If throttle cable becomes dry (non-lube). Recommend use lubricating grease, oil, or WD-40 before use. This also helps ease cable friction wear and tear in throttle cable's sleeves, use lubricating tools to help grease where inner throttle sleeve and cable inside line ONLY.
Recommended use hairspray to help ease of rubber grip set slide onto the handlebar left-side and onto the throttle sleeve right-side. Hairspray will allow it to tack dray in minutes, thus allowing grip usage after 10-15 minutes applied. Or if available use an air-compressor wedge open a tiny air pocket in front of the rubber grip while pressing from behind grip to slide onto or off the handlebar and onto or off the throttle sleeve without the use of chemicals.
Include the following Throttle grip set.
• 1x Left + Right Throttle Grip Set ID: 22mm (7/8”)
• 1x CVK Throttle Cable L: 76" (6ft 4in)
• Black Sleeve L: 69" / Overall Cable L: 81"
• Made in Taiwan
• Fit Handlebar OD: 22mm (7/8”)
• Fit GY6 125/150cc+
• Fit QMB 49/50cc+
• Fit GET 49/50cc+
Supported Models: 139QMB, GY6, Honda Ruckus, Zuma, Rattler, and virtually any other scooter with these handlebar 7/8” measurements.
Item Weight & Product Dimensions:
• 0.781 pounds | 6.4" (L) x 0.846" (ID) x 2.953" (OD)