SSP-G Secondary Slider (GY6, PCX)

Description: SSP-G Secondary Slider for use in GY6 125cc-150cc+, Honda PCX 125-150cc (2010 and newer), and many others. SSP-G rear converters have aggressively angled slits to provide power where you need it and smooth transitions between belt positions with minimal hang up. The 2 different linear options mean you can give more emphasis to acceleration.

NOTE: Recommend using a new belt with this kit. Belt and the belt drive-facing plates KEEP DRY. All, other areas apply moly-graphite grease when assembling. Example, lubricate slider grooves, slider pins, ball bearing seat, and inner funnel area with heat-resistant moly-graphite grease.

For Honda PCX ONLY you can order a NEW slider seat funnel cover, (Part# 169-279) sold separately, to avoid having to modify the existing Honda PCX OEM slider seat funnel cover mention here:

Honda PCX ONLY Temperature Modification Requirements: You'll need to heat the OEM slider seat funnel cover to expand it in order to fit immediately into the freezing assembled NCY Secondary Slider w/OEM rear pulley plate shaft of your Honda PCX. Users assume full responsibility and risk doing so without the purchase of a NEW slider seat funnel cover, Part# 169-279.

Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.

Specifications:

Includes the following Secondary slider (torque driver) and O-rings.

•    1x Secondary Slider Plate OD: 142mm / Funnel ID: 34mm / OD: 43mm / H: 47mm
•    2x Rubber O-rings
•    Made in Taiwan
•    Fit Clutch: 120mm / Nuts: M12, M28 / Washer: M12 / Bearing Funnel: 43mm / Bell Spline: 19 / Socket: 17mm, 19mm, 39mm
•    Fit Compression Spring: 1k, 1.5k, 2k rpm
•    Fit Clutch Springs: 1k, 1.5k, 2k rpm
•    Fit Belt Size: 743, 835, 842-20-30 (Fit GY6 ONLY)
•    Fit Belt Size: 816, 836-22-30 (Fit PCX ONLY)
•    Fit Dowel Pin Set (8x10mm)
•    Fit GY6 125/150cc+
•    Fit PCX 125/150cc+

Supported Models: SSP-G CVT KIT (Part# 169-530); GY6 152QMI 157QMJ 161QMK 161QML Chinese Scooter, ATV, Genuine Buddy, Kymco, Polaris RZR 170, Honda PCX 125/150cc (2010 and newer), Ruckus, Vento

-----
Item Weight & Product Dimensions:
•    0.956 pounds | 5.595" (L) x 1.339" (ID) x 1.85" (H)